Install Additional Hardware
Add Packet Bus Support
Save Translations (CallVisor ASAI)
Return to Task List
1
If the system is high or critical reliability, type
system is in the
2
Type
save translation
information in memory and write it to the translation cards.
3
Update backup translation cards, if required.
Add Packet Bus Support
Return to Task List
You may need to add packet bus support when adding ISDN - BRI or CallVisor ASAI port circuit packs.
NOTE:
Installing TN570D expansion interface circuit packs as part of adding packet bus support
requires a service interruption. Give the customer advance notice of the scheduled
addition.
Task List: Add Packet Bus Support
•
Disable Alarm Origination (Packet Bus Support)
•
Save Translations (Packet Bus Support)
•
Power Down Cabinet (Packet Bus Support)
•
Install Circuit Packs (Packet Bus Support)
•
Power Up System (Packet Bus Support)
•
Test the Packet Bus and C-LAN Circuit Pack (Packet Bus Support)
•
Resolve Alarms (Packet Bus Support)
•
Enable Scheduled Maintenance and Alarm Notification (Packet Bus Support)
•
Save Translations (Packet Bus Support)
If installing TN570D Expansion Interface circuit packs as part of adding packet bus support, then service
is interrupted. Notify the customer in advance as to when the addition will be carried out.
If not installing TN570D circuit packs, then service is not interrupted and you can skip to
Packs (Packet Bus Support)
588
mode.
active/standby
and press Enter. This instructs the system to take all translation
on page 589
on page 589
on page 590
on page 592
on page 593
on page 589
status system 1
and press Enter to verify that the
on page 589
on page 589
on page 592
SI Installation and Upgrades
on page 592
Install Circuit
June 2004