Avaya MCC1 Installation And Upgrades page 624

Add IP Solutions
Task list: Install the TN802B in Media Processor mode
2
Type
change node-names
3
On Figure 244, Node Names - Screen 2,
TN802B.
4
Type
change circuit-pack
5
On Figure 245, Circuit Packs - Screen 1,
DSMAPD
6
If not, type MEDPRO in the slot just above TN802B slot, and press Enter. Changing the one
entry automatically changes the entry above it. If it is in IP Trunk mode, you get the following
error message:
MedPro type requires TN802 with application. Type MEDPRO on circuit-packs form.
7
Type change ip-interfaces
8
On Figure 246, IP Interfaces - Screen 1,
Interface,
9
Set the Enabled field to y, and press Enter.
NOTE:
The customer provides the IP address, subnet mask, and gateway address.
At this time the TN802B LCD reads
with the asterisk flashing.
Figure 244: Node Names - Screen 2
change node-names
Name
clan-a1
clan-b1
default
med-a1
624
and press Enter.
and press Enter.
or .
MEDPRO
and press Enter.
IP Address
192.168.1 .31
192.168.2 .31
0 .0 .0 .0
192.168.1 .81
. . .
. . .
. . .
on page 624, type in the node name and IP address for the
on page 625, check the Code column to see if it says
on page 625, type in the information for the TN802B IP
, and about 3 to 4 minutes later reads
PC BOOT *
NODE NAMES
Name
.
.
.
.
.
.
.
MEDPRO
Page 2 of 6
IP Address
. .
. .
. .
. .
. .
. .
. .
SI Installation and Upgrades
June 2004
*