Install and Connect SCC1 (Single-Carrier Cabinets)
Connect Time Division Multiplexing Bus Cables
1
At the front of the cabinets, align the holes in the top of the front ground plate with the holes at the
bottom of the upper cabinet, and insert the four screws. Do not tighten the screws yet. See
127, Rear Ground Plate and Front Plate or Cabinet Clip — Side View,
2
At the front of the cabinets, align the holes in the bottom of the front ground plate with the holes
at the top of the lower cabinet. Insert the four supplied #12-24 x 1/2-inch (1.27 cm) thread-
forming screws. Do not tighten the screws yet.
3
Repeat Steps 1 and 2 until all stacked cabinets are fastened together.
4
Tighten all screws securely.
Figure 128: Rear Ground Plate and Front Plate or Cabinet Clip — Side View
Figure notes
1
Front Ground Plate or Cabinet Clip
Return to Task List
394
1
2
2
3
on page 393.
3
grdpltec LJK 031096
Battery
Rear Ground Plate
SI Installation and Upgrades
Figure
June 2004