Avaya MCC1 Installation And Upgrades page 396

Install and Connect SCC1 (Single-Carrier Cabinets)
Connect Time Division Multiplexing Bus Cables
Connect System Cables
Return to Task List
1
Connect the cables for critical reliability Expansion Port Networks (EPNs) as shown in
121, Connections for High or Critical Reliability Systems,
Connections
2
Connect the cables for high or critical reliability Processor Port Networks (PPNs) as shown in
Figure 122, Connections for High or Critical Reliability Systems,
NOTE:
The fiber optic cables are connected to the Main Distribution Frame (MDF) in
Telecommunications Cabling
Cables
and routing through lightguide equipment.
3
Connect the fiber optic cable.
The Customer Service Document (CSD) provides an "Inter-Cabinet Cable Running List." Each
row on the list represents a cable connection. Use the running list to determine where to connect
each fiber optic cable.
CAUTION:
Do not route fiber optic cables and the B25A cables together.
For standard reliability fiber connections: see
Systems,
For high reliability fiber connections: see
on page 400 for a sample cable routing.
For Critical Reliability Fiber Connections: see
Systems,
4
Route the fiber optic cable up toward the top of the cabinet. The excess cable should be looped
and draped from the B25A cable clamp on the top ground plate in the stack. See
Single-Carrier Cabinet Fiber Routing,
5
Dress the cable by tie wrapping it to the outside of the B25A cable clamp.
396
on page 398.
on page 763 for information about connecting to optical cross-connect hardware
on page 399 for a sample cable routing.
on page 401 for a sample cable routing.
on page 387 and in
on page 403. Refer to Connecting and Handling Fiber Optic
Figure 132, Connections to Standard Reliability
Figure 133, Connections to High Reliability Systems,
Figure 134, Connections to Critical Reliability
on page 398.
SI Installation and Upgrades
Figure
Inter-Cabinet Cable
on page 388
Install
Figure 131,
June 2004