Avaya MCC1 Installation And Upgrades page 182

Install Fiber Optic Cable Pass-Thru Kit for MCC1 (Multicarrier) Cabinets
Install the fiber optic cable pass-thru kit (MCC1)
Figure 13: Remove the fan cover
Install the Pass-Thru Kit
Return to Task List
1
Snap the beige SC-SC fiber optic adapter onto the pass-thru tool. See
adapter and pass-thru tool,
Use the beige adapter even if single-mode fiber is being installed. The beige adapter is better
suited for cable routing in the next steps.
If single-mode fiber is being installed, the beige adapter will be replaced with a blue adapter later.
2
Slide the pass-thru tool to the rear of the cabinet. See
185.
3
Slide the tool to the rear of the cabinet.
CAUTION:
Avoid bending fiber optic cables to a radius smaller than 1.5 inches (3.8 cm), to prevent
mechanical stress on the cables.
182
X
D I
A U
S S
R M R M
A LA A LA
E R E R TR TR
E M E M
lcda3fop EWS 110398
on page 184.
Figure 14, Fiber optic
Figure 15, Insert the pass-thru tool,
SI Installation and Upgrades
on page
June 2004