Chapter 2: Installing The Mp160; Adding And Removing The Mp160 - Avaya G450 Manual

Chapter 2: Installing the MP160

Adding and removing the MP160

Before you begin
The G450 main board has four slots for VoIP engines. You can install up to two MP160 (Media
Processor 160). An MP160 provides 160 channels for voice transport.
Note:
The G450 supports up to 320 active channels for voice transport. You can install up to two
MP160 modules, or a combination of Media Processor modules with a total of up to 320
channels for voice transport, for example, one MP160 and two MP80s.
See the table below for permitted combinations of Media Processor modules:
Combination of
cards
Combination #1
Combination #2
Combination #3
Combination #4
Important:
You can only install the MP160 in slots 2 and 4 on the G450 1.x or slots 1 and 2 on the G450
2.x. (see
3: Location of MP160 module slots in a G450 2.x
button is to the right of the RST button. On the G450 2.x, the RST button is above the ASB
button.
You can also use the show system command in the command line interface to identify the
mainboard HW vintage (version).
Electrostatic alert:
Hold modules only by the edges to avoid damage from static electricity. Do not touch the
top or bottom of the circuit board. If possible, wear a wrist-strap and use an anti-static
bag.
Configuring V.150.1 on the Avaya G450 Branch Gateway
MP20
-
1 or 2
-
1
Figure 2: Location of MP160 module slots in a G450 1.x
MP80 MP160
- 1 or 2
- 1
1 or 2 1
1 1
on page 10) On the G450 1.x, the ASB
on page 9 and Figure
July 2012 7