Task List: Upgrade Tn802 To Tn2302Ap - Avaya MCC1 Installation And Upgrades

Task List: Upgrade TN802 to TN2302AP

Perform these tasks to upgrade the TN802 to TN2302AP:
1
Perform Pre-upgrade Administration
2
Remove the Circuit Packs
3
Replace the Cables
4
Install the Circuit Packs
5
Administer and Test
Perform Pre-upgrade Administration
Return to Task List
1
Type
list configuration all
2
Type
display port UUCSSppp
the TN802 circuit pack port.
3
Type change trunk-group number
4
Repeat steps1 through 3 for each port.
5
Type
remove ds1 UUCSS
Remove the Circuit Packs
Return to Task List
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against electrostatic
discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN799 and TN2302AP circuit packs are hot-swappable, so you do not need to power
down the carrier to remove or install them.
1
Press the recessed Reset button on the TN802 circuit pack until
LCD. When
2
Remove the TN799 and TN802 circuit packs.
Replace the Cables
Return to Task List
1
Disconnect the network cable from the Ethernet connection.
2
Turn off the monitor and unplug it from the AC outlet, if necessary.
3
Disconnect the monitor, keyboard, and mouse from the H600-512 external cable assembly, if
necessary.
4
Turn off the modem and unplug it from the AC outlet.
5
Disconnect the modem's RS232 port from the H600-512 external cable assembly.
SI Installation and Upgrades
June 2004
on page 611
on page 611
on page 611
on page 612
on page 612
and press Enter to locate all the TN802 circuit pack ports.
and press Enter to find the trunk group number associated with
and press Enter. Go to screen 4. Delete all the TN802 ports.
and press Enter.
is in a steady state, it is safe to remove the circuit pack.
MSHUT*
Add IP Solutions
Task List: Upgrade TN802 to TN2302AP
starts flashing on the
MSHUT*
611