Connecting Through A Channel Service Unit - Avaya MCC1 Installation And Upgrades

Connecting Through a Channel Service Unit

Return to Task List
Figure 278, DS1 Converter Connections for T1 Service — Part 2,
connection for a T1 line, and
on page 687 shows a typical connection for an E1 line.
1
Connect the H600-348 Quad Cable to the DTE jacks on each of the 4 CSUs.
2
You may need an adapter cable to connect the H600-348 cable to the CSU (see
Descriptions
3
Connect one end of the H600-383 cable to the network jack on the CSU and the other end to the
smart jack.
Connection to the remote-located system is the same as that shown in
Pack Switches,
Y Cable Lengths
The distinction between facility types is important when using TN1654 circuit packs. The facility used to
carry control channel messages between the pair of DS1 converter circuit packs and all packet traffic is
known as the primary facility. The facility used to backup and takeover for the primary facility in the
event of primary facility failure is known as the secondary facility. The TN1654 allows either facility, A
or B, to be a primary channel. The control channel is restricted to only the A or B facilities. This permits
full 24-channel access (T1) or 31-channel access (E1) for facilities C and D to support user traffic.
SI Installation and Upgrades
June 2004
Figure 279, DS1 Converter Connections for 120-ohm E1 Service — Part 2,
on page 687).
on page 688 and Figure 281, CAMA Numbering Format form,
on page 689 shows theY cable lengths.
Install and Administer Trunks
Add TN1654 DS1 Converter (r only)
on page 686 shows a typical
Adapter
Figure 280, DS1 Converter Circuit
on page 688.
685