Avaya MCC1 Installation And Upgrades page 583

Replace a TN750 or TN750B with a TN750C or
Move all Announcements from a TN750B to a TN750C
Return to Task List
NOTE:
Do not copy or restore announcements from a TN750C to a TN750 or TN750B circuit
pack, as this may corrupt the announcement data.
1
Save announcements from the TN750/B to the mass-storage system.
2
Insert the TN750C circuit pack into a vacant slot of a carrier.
Any carrier is acceptable since power holdover is not a concern.
3
Lift the locking lever upward until the latch pin engages.
4
Administer a new data module on the TN750C circuit pack, as described in Administrator's Guide
for Avaya™ Communication Manager.
5
Type restore announcements
6
Wait until announcements copy from voice RAM to flash memory (yellow LED on the TN750C
stops flashing). This may take about 10 minutes.
7
Type busyout board 01c11
example circuit pack location.
8
Type change integrated announcements
This modifies the translations for the TN750B circuit pack to reference the TN750C circuit pack.
9
Verify proper playback of the announcements from the TN750C circuit pack by calling them.
10
Type release board 01c11
example circuit pack location.
Return to Task List
Add additional TN750C Circuit Packs
Return to Task List
1
Install the TN750C into a vacant slot in a carrier.
Any carrier is acceptable since power holdover is not a concern.
2
Administer a new data module on the TN750C circuit pack, as described in Administrator's Guide
for Avaya™ Communication Manager (555-233-506).
3
Type
change announcements
TN750C slot. Fill in the designated board location field for the circuit pack's location.
4
Record the announcements, as described in Administrator's Guide for Avaya™ Communication
Manager (555-233-506).
5
Wait until the announcements copy from voice RAM to the on-board flash memory (the yellow
LED on the TN750C starts and then stops flashing). This may take about 10 minutes.
Return to Task List
SI Installation and Upgrades
June 2004
Task List: Add Multiple Announcement Circuit Packs
and press Enter to the TN750C circuit pack equipment location.
and press Enter for the TN750/B circuit pack, where "
and press Enter.
and press Enter for the TN750/B circuit pack, where "
and press Enter to administer new announcements to that
Install Additional Hardware
01c11 " is an
01c11 " is an
583