Test Tone-Clock For Each Expansion Port Network; Test Tone-Clock Interchange For Each Expansion Port Network; Test Expansion Interface Exchange For Each Expansion Port Network - Avaya MCC1 Installation And Upgrades

Test Tone-Clock for Each Expansion Port Network

Return to Task List
1
Type test tone-clock 2A
installed, and press Enter.
If any result is
Expansion Port Network (EPN).
2
Repeat Step 1 for each installed Tone-Clock circuit pack.

Test Tone-Clock Interchange for Each Expansion Port Network

Return to Task List
If the system is critical reliability, test the Tone-Clock interchange for each Expansion Port Network
(EPN).
1
If Multi-Carrier Cabinet (MCC1), type
or
If Single-Carrier Cabinet (SCC1), type
This displays the location of the Standby Tone-Clock.
2
Type
set tone-clock xx
Enter.
3
If Multi-Carrier Cabinet (MCC1), type
or
If Single-Carrier Cabinet (SCC1), type
4
Verify the duplicated Tone-Clock is active using the information displayed on the screen.
If any problems are indicated, check the TDM cables in the associated Expansion Port Network (EPN).
Return to Task List

Test Expansion Interface Exchange for Each Expansion Port Network

Return to Task List
If the system is critical reliability, test the expansion interface exchange for each Expansion Port Network
(EPN).
1
If Multi-Carrier Cabinet (MCC1), type
or
If Single-Carrier Cabinet (SCC1), type
This displays the standby expansion link. See
Expansion Link is Set,
2
Type
set expansion-link UUCSS
of the standby expansion link.
3
Verify the bottom of the screen displays:
Command successfully completed
Command
SI Installation and Upgrades
June 2004
where 2A is the cabinet and carrier number for one of the Tone-Clocks
, check the associated TDM bus cables and intercabinet cables in the
FAIL
where is the Port-Network/Carrier for the Standby Tone-Clock. Press
xx
on page 496.
where
:
status system cabinet number <1-44>
status system all-cabinets
status system cabinet number <1-44>
status system all-cabinets
status system cabinet number <1-44>
status system all-cabinets
Figure 190, Sample of System Status before
is one of the cabinet, carrier, and port locations
UUCSS
Test the System
LED Indicators
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
495