Hard-Wire Bridging; Dual Wiring Of Two-Wire And Four-Wire Endpoints - Avaya MCC1 Installation And Upgrades

Install and Wire Telephones
Task List: Attendant Console Procedures

Hard-Wire Bridging

Analog type hard-wire bridging is not allowed for four-wire (only) DCP endpoints. Hard-wire bridging
provides no way of combining the digital output of two bridged DCP sets. Also, a bridged endpoint
causes degradation of the DCP signal.
CAUTION:
Bridging or paralleling these endpoints can cause electrical damage to the consoles or
cause the circuit pack to remove power from the consoles.
Dual Wiring of Two-Wire and Four-Wire
Endpoints
Do not simultaneously wire a two-wire and four-wire endpoint to the same equipment location in an
MDF. The Avaya Media Server or Gateway uses separate circuit packs to interface two- and four-wire
endpoints.
Install the Attendant Console
Return to Task List
1
Install the Attendant Console and connect the modular cord to the information outlet.
2
Install labels per the Attendant Console form and the Display Module form assignments.
3
Install a Digital Line circuit pack in the assigned carrier slot (if an additional circuit pack is
required).
4
Administer the forms listed in "Attendant Console" in Administrator's Guide for Avaya
Communication Manager (555-233-506).
Figure 200: 302C1 Console
Return to Task List
518 SI Installation and Upgrades
June 2004