Add U.s. Robotics Model Usr 33.6 Ext External Modem To Ppn - Avaya MCC1 Installation And Upgrades

2
Connect the opposite end of the RS-232 cable to a dumb terminal.
3
Set the dumb terminal to full duplex mode.
4
Type AT&N6 to set the baud rate to 9600.
The modem connects at 9600 baud but throughput is at 1200 baud.
5
Type AT&W0 to save the setting into non-volatile RAM.
6
Set Switch 5 to the OFF (up) position to disable auto answer.
7
Disconnect the RS-232 cable from the terminal and connect it to the TERMINAL connector on
the rear of the system cabinet.
Figure 285: Connect External Modem to EPN
cydfepnm KLC 100397
Figure notes
1 U.S. Robotics External Modem
2 RS-232 Cable
Return to Task List
Add U.S. Robotics Model USR 33.6 EXT
External Modem to PPN
Return to Task List
1
Connect an RS-232 cable to the modem. See
page 706.
NOTE:
In the following steps, a PC with Windows 95 or Windows NT 4.0 may be substituted for
the dumb terminal. Use the Hyperterminal (terminal emulation) application.
2
Connect the opposite end of the RS-232 cable to a dumb terminal.
3
Set the dumb terminal to full duplex mode.
4
Type AT&N6 to set the baud rate to 9600.
The modem connects at 9600 baud but throughput is at 1200 baud.
5
Type AT&W0 to save the setting into non-volatile RAM.
6
Set Switch 5 to the OFF (up) position to disable auto answer.
SI Installation and Upgrades
June 2004
3
TERMINAL
3 Expansion Port Network
Figure 286, Connect External Modem to PPN,
Install and Connect Modems
Task List: Install and Connect Modems
1
2
on
705