Avaya MCC1 Installation And Upgrades page 729

NOTE:
In most cases, the image with the more recent date and time stamp is the new firmware
image file.
4
Type set boot-image board UUCSS image 1 | 2
Example: set boot-image board 1C07 image 2
The system responds with
5
Type get boot-image UUCSS
target circuit pack.
get boot-image 1C07
Image 1
Board Type: TN2501
FW Vintage: 02
HW Signature: 02
Suffix: A
Date: 09/13/02
Timestamp: 10:30:50
CRC Checksum: Good
Active Image: Yes
Reboot Image: No
Note that the values in the Reboot Image field has changed.
NOTE:
If a TN799C/DP C-LAN or TN2501 VAL circuit pack, reseat them to activate the new
firmware image. Go to
6
Type
get boot-image UUCSS
pack.
get boot-image 1C07
Image 1
Board Type: TN2501
FW Vintage: 02
HW Signature: 02
Suffix: A
Date: 09/13/02
Timestamp: 10:30:50
CRC Checksum: Good
Active Image: No
Reboot Image: No
7
Ensure that both the Active Image and the Reboot Image fields are as you expect.
SI Installation and Upgrades
June 2004
Command Successfully Completed
and press Enter to check the status of the firmware images on the
DISPLAY FIRMWARE IMAGE(S)
Image 2
TN2501
01
02
A
05/06/02
12:42:18
Good
No
Yes
Reseat VAL circuit pack
to check the status of the firmware images on the target circuit
DISPLAY FIRMWARE IMAGE(S)
Image 2
TN2501
01
02
A
05/06/02
12:42:18
Good
Yes
Yes
Upgrade Firmware on Programmable Circuit Packs
Self and C-LAN-distributed download Procedure
and press Enter.
.
on page 726.
729