Task List: Install The Remote Network Interface - Avaya MCC1 Installation And Upgrades

Install and Wire Telephones

Task List: Install the Remote Network Interface

Task List: Install the Remote Network Interface
1
Install the Remote Network Interface
2
Install Off-Premises Station Wiring
Figure 201: Connections at Trunk/Auxiliary Field
Figure notes
1 To Network Interface Facility
2 To Control Carrier Auxiliary
Connector
Install the Remote Network Interface
Return to Task List
You must obtain the product identification and the INADS OSS telephone number from the NTSO or the
TSC before you begin to install the Remote Network Interface.
Figure 202, Connections at Trunk/Auxiliary Field,
Interface trunk installation.
1
Determine the network interface trunk appearance at the green trunk/auxiliary field.
2
Label the terminals for the trunk appearance.
3
Install jumpers between the trunk appearance and Remote Network Interface terminals.
4
Enter
change system-parameters maintenance
5
Enter the ten-digit product identification. Enter the INADS OSS telephone number in the First
OSS Telephone Number field.
6
Enter first-only in the Alarm Origination to OSS Numbers field and press Enter to
enable Alarm Origination (to the first OSS).
524
on page 524
on page 525
25
50
IN
r758482b RBP 062696
3 One Pair of Wires
4 Twenty-fifth Pair of RJ21X
Network Interface Jack
on page 525 shows a typical Remote Network
and press Enter.
SI Installation and Upgrades
June 2004