Avaya MCC1 Installation And Upgrades page 630

Add IP Solutions
Task list: Install the TN802B in IP Trunk mode
U.S. Robotics Modem Dip Switch Settings
Dip
Switch
1
2
3
4
5
6
7
8
Return to Task List
Connect the Monitor, Keyboard, and Mouse
Return to Task List
NOTE:
Only make these connections if administered locally. Not necessary if administered
remotely.
You must connect these before inserting the TN802B IP Interface.
1
Attach a VGA monitor to the VGA connector of the TN802 IP Interface external cable assembly.
2
Attach the keyboard to the KEYBOARD connector of the external cable assembly.
3
Attach the mouse to the MOUSE connector of the external cable assembly.
4
Plug the monitor into an AC power receptacle and turn it on.
Return to Task List
630
Setting Description
UP Data Terminal Ready normal
DOWN Data Terminal Ready override
UP Verbal result codes
DOWN Numeric result codes
UP Suppress result codes
DOWN Display result codes
UP Echo offline commands
DOWN No echo, offline commands
UP Auto answer on first ring or higher if specified in NVRAM
DOWN
Auto answer off
UP Carrier detect normal
DOWN Carrier detect override
UP Load NVRAM defaults
DOWN Load factory defaults
UP Dumb mode
DOWN Smart mode
SI Installation and Upgrades
June 2004