Direct connection between the switch and RFA
a
Go to the RFA website, and, following the instructions in the "Deliver to G3r/G3si/G3csi"
chapter of the RFA Job Aid, deliver the License File.
NOTE:
This procedure sends the License File to the switch and installs it.
b
If the system has IP endpoints registered, and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
No connection between the switch and RFA
a
Go to the RFA website, and, following the instructions in the "Deliver to G3r/G3si/G3csi"
chapter of the RFA Job Aid, deliver the License File to your laptop/PC.
b
Open the License Installation Tool (LIT) application at your laptop/PC.
c
Use the LIT instructions to add a switch connection profile to the tool.
d
Use the LIT instructions to install the License File on the switch.
e
If the system has IP endpoints registered, and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
Return to Task List
Adding TTC Japanese 2-Mbit Trunks
Return to Task List
The TN2242 Japan 2-Mbit trunk interconnects the switch with other vendor equipment in Japan as well
as to interconnect other switches through the Time Division Multiplexor device.
1
Determine the port assignment of the trunk from the Trunk Group screen.
2
Install a TN2242 circuit pack in assigned carrier slot.
3
Connect the H600-513 cable from the cabinet to the Time Division Multiplexor device.
4
To administer forms, see the following sections in the Administrator's Guide for Avaya
Communication Manager (555-233-506).
— For ISDN applications, see the ISDN Service section.
— For non-ISDN applications, see the Managing Trunks section.
Return to Task List
Add TN1654 DS1 Converter (r only)
Return to Task List
SI Installation and Upgrades
June 2004
Install and Administer Trunks
Adding TTC Japanese 2-Mbit Trunks
677