Installing The Stratum 3 Clock; Task List: Install The Stratum 3 Clock; Unpack And Inspect Stratum 3 Clock Cabinet; Install And Position Stratum 3 Clock Cabinet - Avaya MCC1 Installation And Upgrades

Installing the Stratum 3 Clock

Use this task list to install a Stratum 3 clock.

Task List: Install the Stratum 3 clock

1

Unpack and Inspect Stratum 3 Clock Cabinet

2

Install and Position Stratum 3 Clock Cabinet

3
Connect AC Power to Stratum 3 Clock Cabinet
4
Check and Connect Commercial AC Power
5
Connect DC Power and Ground to Stratum 3 Clock Cabinet
6
Connect Clock Cabinet Grounding
7
Connect Stratum 3 Clock DC Power
8
Set the Clock Options
9
Cable the Stratum 3 Clock
10
Install the Stratum 3 Clock Wiring
Unpack and Inspect Stratum 3 Clock Cabinet
Return to Task List
1
Check the status of the SHOCKWATCH and/or TILTWATCH indicators on the cardboard
container. If the container has been jarred or tilted beyond specifications, the indicators are red,
indicating possible damage.
2
Remove all packing material.
3
Remove front door and rear screw-on panels from the cabinet.
4
Inspect the cabinet for damage. Report any damage per local instructions.
Install and Position Stratum 3 Clock Cabinet
Return to Task List
Check the location of the AC power receptacle. The receptacle must be on a separately fused circuit that
is not controlled by a wall switch. It must be located within 10 ft (3 m) of the cabinet and should be
located outside the MDF area.
1
Position the clock cabinet in the designated location.
2
If earthquake protection is required, skip to
Earthquake Protection for
3
If earthquake protection is not required, level the cabinets and adjust and lock the cabinet
stabilizing bolts to keep the cabinet from moving.
SI Installation and Upgrades
June 2004
on page 693
on page 693
on page 694
on page 694
on page 694
on page 695
on page 695
on page 696
on page 698
Install Earthquake Protection for SCC
MCC.
Installing the Stratum 3 Clock
Task List: Install the Stratum 3 clock
on page 694
or Install
693