Avaya MCC1 Installation And Upgrades page 636

Add IP Solutions
Task list: Install the TN802B in IP Trunk mode
Assign Server and Domain Names
Return to Task List
The Windows NT server identifies servers using a server name plus a domain name that locates the
named server in a particular part of the network. The TN802B IP Interface is shipped with generic server
and domain names. Assign replacement names that are meaningful within your network.
1
Click on My Computer > Control Panel > Network.
2
Select the Identification tab, then click Change.
3
Type the new server name in the Computer Name field.
4
Type the new domain name in the Domain field and click OK > OK > Close.
5
When prompted to reboot the computer, select one of the following options:
— No if you have not assigned IP addresses; then go to
— Yes if you have assigned IP addresses
Return to Task List
Assign an IP Address
Return to Task List
1
Click on My Computer > Control Panel > Network.
2
Click the Protocols tab.
3
Select TCP/IP Protocol from the list.
4
Click the Properties option in the Network window.
5
On the Figure 252, TCP/IP Properties Window - IP Address, Adapter [1],
the Adapter drop down menu lists 2 DEC Ethernet adapters.
CAUTION:
Do not change any settings on the adapter labeled [1] for any reason.
6
On the Figure 253, TCP/IP Properties Window - IP Address, Adapter [2],
DEC Ethernet adapter labeled [2].
7
Type a valid IP address for the IP Interface server in the IP Address: field.
8
Type the appropriate subnet mask in the Subnet Mask: field.
636
Assign an IP Address on page 636
on page 637, verify that
on page 638, select the
SI Installation and Upgrades
June 2004