Install Additional Hardware
Task List: Add CallVisor ASAI
New simplex and upgraded G3r only
1
Type
save translation
After the translations have been copied (about 10 minutes), the system returns an error code,
which must be a zero; otherwise, the translations are not copied.
2
Type
reset system 3
Wait until the system has completely reset before continuing.
3
If the system has IP endpoints registered, unplug the Ethernet cable from the TN799 (C-LAN)
circuit pack.
This disconnects (unregisters) all IP endpoints.
4
Type
set time
Ensure that the system date and time are set correctly.
5
Use one of these installation methods:
—
Direct connection between the switch and RFA
—
No connection between the switch and RFA
New or upgraded G3si only
1
Retrieve the RFA License File with both serial numbers from the RFA Application.
2
If the system has IP endpoints registered, unplug the Ethernet cable from the TN799 (C-LAN)
circuit pack.
This disconnects (unregisters) all IP endpoints.
3
Type
set time
Ensure that the system date and time are set correctly.
4
For duplicated systems only type
Ensure that the standby SPE is not in the maintenance state. If it is, wait for the maintenance state
to finish.
5
Use one of these installation methods:
—
Direct connection between the switch and RFA
—
No connection between the switch and RFA
Direct connection between the switch and RFA
a
Go to the RFA website, and, following the instructions in the "Deliver to G3r/G3si/G3csi"
chapter of the RFA Job Aid, deliver the License File.
NOTE:
This procedure sends the License File to the switch and installs it.
b
If the system has IP endpoints registered, and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
No connection between the switch and RFA
a
Go to the RFA website, and, following the instructions in the "Deliver to G3r/G3si/G3csi"
chapter of the RFA Job Aid, deliver the License File to your laptop/PC.
586
and press Enter.
and press Enter.
and press Enter.
and press Enter.
status system all
and press Enter.
SI Installation and Upgrades
June 2004