Loudspeaker Paging Access Without Universal Coupler; Loudspeaker Paging With Universal Coupler - Avaya MCC1 Installation And Upgrades

Loudspeaker paging access without universal
coupler
1
Determine port assignment of paging zone(s) from loudspeaker paging form.
2
At the main distribution frame, locate the connecting block and terminals assigned to the selected
port.
3
On the locally engineered wiring block, place a strap between terminals S and SZ. Place a strap
between terminals S1 and SZ1.
4
Install patch cord/jumper wires at the main distribution frame.
5
Connect a 2-pair line cord (modular plug at one end) from the information outlet to the paging
amplifier (to the loudspeaker system).
6
Install loudspeaker equipment according to the manufacturer's instructions.
7
Administer the switch for the new equipment.

Loudspeaker paging with universal coupler

An information outlet provides access to loudspeaker paging. The system side of the main distribution
frame connects to a 909A/B universal coupler. Make provisions for the DC power that the 909A/B
universal coupler requires, such as a 1151A, 1151A2, or other approved -48VDC power supply.
Six leads (T, R, SZ, SZ1, S, and S1) connect the adapter to an auxiliary trunk circuit pack located in a port
carrier.
1
Determine port assignment of paging zone(s) from loudspeaker Paging form.
2
Identify carrier slot and label both ends of an A25D (male to male) cable.
3
Connect a cable from the 909A/B to the system side of the main distribution frame. A wiring
block must be locally engineered.
4
909A/B universal coupler
universal coupler and the wiring blocks.
CAUTION:
Damage to the 909A/B may occur if the cable is plugged into J3 before all cross-connects
are completed.
5
On the 909A/B universal coupler:
•
Connect seizure control voltage of from -9 to -70 volts to the PG2/BZ2 connection (pin 2
of J1). Switching voltage to the PG2/BZ2 connection can be from the 909's -48-volt
supply.
•
Connect a -48 VDC power source to the -48 and GRD terminals on the 909A/B.
6
Install patch cord/jumper wires at the main distribution frame.
7
Connect a 2-pair line cord (modular plug at one end) from the information outlet to the
loudspeaker system.
8
Install loudspeaker equipment according to the manufacturer's instructions.
SI Installation and Upgrades
June 2004
on page 831 provides details of the connections between the 909A/B
Adjuncts and Peripherals
Paging and announcement equipment
841