Add Circuit Packs (Ds1 Tie And Ops Trunks); Install Cables (Ds1 Tie And Ops Trunks); Power Up System (Ds1 Tie And Ops Trunks); Enter Added Translations (Ds1 Tie And Ops Trunks) - Avaya MCC1 Installation And Upgrades

Install and Administer Trunks
Add DS1 Tie and OPS Trunks

Add Circuit Packs (DS1 Tie and OPS Trunks)

Return to Task List
1
Determine the port assignments of the circuit packs to be added.
2
Install the TN722B DS1 Tie Trunk, the TN767E DS1 Interface, or TN464GP DS1 Interface
circuit pack in assigned carrier slot.
3
Replace an existing TN756 Tone Detector/Generator circuit pack with:
— TN768, TN780, or a non-United States TN419B Tone-Clock
— TN748B or a non-United States TN420B Tone Detector
— TN2182 Tone-Clock

Install Cables (DS1 Tie and OPS Trunks)

Return to Task List
Install H600-307 cable from the cabinet to a Channel Service Unit (CSU) and install cables from the CSU
to the MDF as required.

Power Up System (DS1 Tie and OPS Trunks)

Return to Task List
1
At each EPN, set the main circuit breaker to ON.
2
At the PPN, set the main circuit breaker to ON.
3
The system performs the level 4 rebooting process, loading the system translations from the
translation card or removable media. Rebooting takes 8 to 11 minutes.
4
After the system reboot is finished and all trouble is cleared, verify that the EMERGENCY
TRANSFER CONTROL switch is set to AUTO. This restores the system to the normal mode.
Return to Task List
Enter Added Translations (DS1 Tie and OPS
Trunks)
Return to Task List
Administer forms listed under "DS1 Tie Trunk Service" in Administrator's Guide for Avaya
Communication Manager (555-233-506).

Save Translations (DS1 Tie and OPS Trunks)

Return to Task List
674 SI Installation and Upgrades
June 2004