Administering Cdr Data Collection - Avaya MCC1 Installation And Upgrades

Administering CDR Data Collection

NOTE:
To send CDR data via CLAN to a device on the LAN/WAN, you have the option to
enable/disable RSP.
1
Setup the CDR adjunct to be ready to collect CDR data. Record the IP address and the port
number of the CDR adjunct, which could be a terminal server or a CDR application that uses
RSP.
If the CDR adjunct is an application that uses RSP, start the application to listen for a client
connection at the port.
2
Access the Node Names screen in Communication Manager (see
on page 803), and do the following:
a
Enter the CDR adjunct's name from step 1 in the Name field.
b
Enter the CDR adjunct's IP address in the IP Address field.
3
Access the IP Services screen in Communication Manager (see
page 803), and do the following:
a
In the Service Type field, enter CDR1 or CDR2.
b
In the Local Node field, enter switch-clan.
c
The Local Port field defaults to
in this field.
d
In the Remote Node field, enter the node name you assigned to the CDR adjunct in step
2.
e
In the Remote Port field, enter the port number used by the CDR adjunct determined
in step 1.
4
Go to Page 3 and do the following:
a
Enter y in the Reliable Protocol field if you have a CDR application using RSP.
Enter n if the CDR adjunct is connected through a terminal server.
b
If RSP is being used, complete the Packet Resp Timer and Connectivity
Timer fields with some reasonable value that matches the network condition (the
recommended values are 30 and 60 seconds, respectively).
c
Leave the defaults in the other fields.
5
Administer CDR parameters as described in
SI Installation and Upgrades
June 2004
Adjuncts and Peripherals
Administering IP node names
Administering IP services
for all client applications. You cannot make an entry
0
Administering CDR parameters
Call detail recording (CDR)
on
on page 806.
805