Option Switch Settings
Call Detail Recording Option Settings
572 Printer Used as System Printer
Function
83
84
85
91
92
93
94
95
96
Return to Task List
Call Detail Recording Option Settings
Return to Task List
The interface between the system and Call Detail Recording (CDR) equipment may be one of the
following:
•
Data Module — Recommended option settings are shown in
Control Modems
•
Modem — Recommended option settings are in modem vendor document
•
TN726B Data Line circuit pack and an Asynchronous Data Unit — Data modules or modems are
not required.
•
Connected directly to the DCE connector (Electronic Industries Association [EIA] Port) located
on the rear of the Control Carrier — Data modules or modems are not required.
A 572 Printer can be used as an output receiving device for Call Detail Recording (CDR). The
recommended option settings for this printer are shown in
CDR, and Journal Printer
TELESEER, Call Detail Recording (CDR), 94A Local Storage Unit (LSU), or Customer Premises
Equipment (CPE) can be used as the output receiving device.
Administration procedures for Call Detail Recording (CDR) equipment are provided in Administrator's
Guide for Avaya Communication Manager (555-233-506).
752
Function Name
REQUEST TO SEND (RTS) TIMING
CD
CLEAR TO SEND (CTS)
OVER RUN
DATA BIT
PROTOCOL
STOP BIT
PARITY
PBS
on page 753.
on page 753 and
572 Printer Used as System Printer
Menu
Menu Status
01
RTS
02
OFF
02
OFF
02
256
02
8
03
XON/XOFF
01
1
01
NONE
04
1200
2 of 2
Options for D-Lead and Attention
572 Printer Used with Management Terminal,
on page 755. Also, a
SI Installation and Upgrades
June 2004