Check Circuit Pack Configuration - Avaya MCC1 Installation And Upgrades

Figure 182: Sample System Status Screen for Cabinet 2 (Page 2 of 3)
status system all-cabinets
SPE MODE
1A active
1B maint/init
SERVICE CONTROL
TDM STATE CHANNEL
2A in
2B in
EMERGENCY
TRANSFER
2A
Return to Task List

Check Circuit Pack Configuration

Return to Task List
The list configuration report provides a list of circuit packs connected to the system and recognized by
the software.
1
Type
list configuration all
2
Verify the screen displays list configuration similar to
Screen — Page 1,
(except power supply circuit packs). Do not attempt to correct any problems until after the
diagnostic tests that you run later in the system tests.
3
Note any boards with a VINTAGE column entry of NO BOARD or CONFLICT.
NOTE:
A u indicates unassigned ports, and a number indicates the port has been translated.
SI Installation and Upgrades
June 2004
SYSTEM STATUS CABINET 2
SELECT SPE ALARMS
SWITCH MAJOR MINOR
auto 0
auto 0
DEDICATED
TONES PKT
y n 2
n y
SELECT
SWITCH EXP-LINK
auto-on 01A01-02A01
01B01-02B02
and press Enter.
on page 490. Make sure the software is communicating with each circuit pack
Page
TONE/ SERVICE SYSTEM
CLOCK STATE CLOCK
0 2A in
0 2B in
SERVICE BUS ALARMS
STATE MAJOR MINOR
SERVICE CABINET
STATE MODE TYPE
in standby MCC
in active
Figure 183, Sample System Configuration
Test the System
LED Indicators
2 of 3 SPE A
SYSTEM
TONE
active active
standby standby
BUS OPEN BUS
FAULTS LEADS
489