Avaya MCC1 Installation And Upgrades page 608

Add IP Solutions
Task List: Install TN2302AP
3
On page 2, type in the node names and IP addresses for the TN799x and the TN2302AP.
NOTE:
The customer or design team provides the actual name and address. Suggest a generic
name and not one tied to the circuit pack.
4
Type
display circuit-pack
column.
5
Type
change ip-interfaces
NOTE:
The customer provides the IP address, subnet mask, and gateway address.
6
Type in the following information for the TN2302AP IP Media Processor and TN799x C-LAN:
— Set Slot field to UUCSS.
— The Code and SFX fields are automatically populated with TN799x and TN2302AP.
— In the Node Name field type the same node name entered on the Node Name screen.
— In the Subnet Mask field use the default setting unless you are given a different subnet
mask.
— In the Gateway Address field use the address you are given or leave blank.
— Set the Net Region field to 1 unless you are given a different number.
— Set the Enable Eth Pt field to y
7
Press Enter to save the information and effect the new settings.
Refer to the Administration for Network Connectivity for Avaya™ Communication Manager (555-233-
504) for more information on these administration steps and for the steps to administer IP Softphones and
H.323 trunks.
NOTE:
The administration of the TN2302AP is the same as that for the TN802B.
608
and press Enter. Verify that the TN2302AP shows up in the Code
and press Enter. See Figure 237, IP Interfaces screen, on page 609
SI Installation and Upgrades
June 2004