Avaya MCC1 Installation And Upgrades page 263

2
Behind control cabinet A of the single-carrier EPN:
— Install the same kind (either 9823-A or 9823-B) of lightwave transceiver on cable
connector at slot 2A01.
— Connect the fiber-optic cable, coming from control cabinet A of the PPN, to the 9823-type
lightwave transceiver at slot 2A01.
— Delicately attach the fiber-optic cable (with cable ties) to the rear covers of the EPN stack.
— Coil up the surplus length of fiber-optic cable, and place the coil either in the cable
manager or on the bottom shelf (holding the power supply) of the PPN cabinet.
3
Behind control cabinet B of the single-carrier PPN:
— Install a 9823-type lightwave transceiver on the connector at slot 1B01.
— Connect one end of a fiber-optic cable to the 9823-type lightwave transceiver at slot 1B01.
— Route the fiber-optic cable from the 9823-type lightwave transceiver to the cabinet's cable
tray and downward out of the cabinet to the EPN stack.
— Delicately attach the fiber-optic cable (with cable ties) to the wall of the cable tray at the
built-in cable-tie positions.
4
Behind port cabinet B of the single-carrier EPN:
— Install the same kind (either 9823-A or 9823-B) of lightwave transceiver on cable
connector at slot 2B02.
— Connect the fiber-optic cable, coming from control cabinet B of the PPN, to the 9823-type
lightwave transceiver at slot 2B02.
— Delicately attach the fiber-optic cable (with cable ties) to the rear covers of the EPN stack.
— Coil up the surplus length of fiber-optic cable, and place the coil either in the cable
manager or on the bottom shelf (holding the power supply) of the PPN cabinet.
SI Installation and Upgrades
June 2004
System 75 XE to R8si (Blowback)
Task List: System 75 XE to R8si
263