Installing Tn1654S In A Switch Node Carrier - Avaya MCC1 Installation And Upgrades

Figure 276: DS1 Converter Connections — Part 1
cydf010 KLC 091399
Figure notes
1 Port cabinet
2 Backplane connector for TN570D EI
3 Backplane connector for TN1654 DS1
Converter
4 50-pair female connector to EI
connector
Return to Task List

Installing TN1654s in a Switch Node Carrier

Return to Task List
You can install up to 2 TN1654 circuit packs in a Switch Node Carrier.
1
Install the TN1654 circuit pack in either slot 1 or 21 of the Switch Node Carrier close to a
TN573B SNI circuit pack.
CAUTION:
Install the TN1654 circuit pack in either slot 1 or slot 21. Installing it in any other slots can
damage the circuit pack and the system. Do not do it.
2
On the backplane, connect a 14-inch (35.56 cm) Y cable from the TN1654 circuit pack to the
TN573B circuit pack. See
CAUTION:
The Y cable used with the TN1654 circuit pack is different than the Y cable used with the
TN574 circuit pack. These cables are NOT interchangeable.
SI Installation and Upgrades
June 2004
1
20 19 18 17 16 15 14 13 12 11 10 09
Figure 277, DS1 Converter Connections — Part 1,
Add TN1654 DS1 Converter (r only)
08 07 06 05 04 03 02 01
4
5 14-in. (35.6 cm) Y cable
6 50-pin male/50-pin female double-
headed connector
7 H600-348 Quad Cable (with 50-pin
male connector), which connects the Y
cable to the 4 CSUs.
Install and Administer Trunks
2
3
6
7
A
5
on page 684.
683