Avaya MCC1 Installation And Upgrades page 621

Install the Circuit Packs
Return to Task List
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against electrostatic
discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The circuit packs are hot-swappable, so you do not need to power down the carrier to
install them.
If you need to remove the TN802B IP Interface from the carrier at a later time, shut down
Windows NT first by pressing the recessed reset button on the faceplate (see
TN802B IP Interface faceplate,
shows a flashing
min), it is safe to remove the circuit pack.
NOTE:
If replacing the existing TN799 circuit pack, remove it first and replace it with the new
one.
To properly seat the circuit pack, push firmly on the front of the faceplate until the latch
reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.
1
Insert the TN799x circuit pack into the port slot identified earlier.
2
Insert the TN802B IP Interface into the rightmost of the three slots you reserved for it (see
243, J58890MA-1 L30 IP Interface Assembly,
When you plug in the TN802B IP Interface, the circuit pack starts to boot and the LCD reads PC
Boot. The circuit pack automatically reboots, and after about 3 to 4 minutes, the LCD changes to
MEDPRO*.
If the TN802B is pre-administered at the factory, it reboots several times to initialize to MedPro
mode.
NOTE:
For an initial installation, the TN802B IP Interface needs to be administered first.
If the TN802B is not pre-administered, go to
SI Installation and Upgrades
June 2004
Task list: Install the TN802B in Media Processor mode
on page 622) of the TN802B IP Interface until the LCD
. When the flashing stops and the asterisk disappears (about 2
MSHUT*
on page 623) and seat it properly.
Add IP Solutions
Administer the IP Interface
Figure 242,
Figure
on page 623.
621