Installing Tn1654S In A Port Carrier - Avaya MCC1 Installation And Upgrades

Install and Administer Trunks
Add TN1654 DS1 Converter (r only)
Examples of typical settings
Switch Settings
1 2 3 4 5 6
swdft1es KLC 092799
1 2 3 4 5 6
swdft1d4 KLC 092799
1 2 3 4 5 6
swdfe1es KLC 092799
Return to Task List

Installing TN1654s in a Port Carrier

Return to Task List
1
Install the TN1654 circuit pack in any slot in a Port Carrier close to a TN570D Expansion
Interface circuit pack.
2
On the backplane, connect a 14-inch (35.56 cm) Y cable from the TN1654 circuit pack to the
TN570D circuit pack. See
3
The Y cable used with the TN1654 is different than the Y cable used with the TN574. These
cables are NOT interchangeable.
4
Connect an H600-348 Quad cable to the other side of the double-headed Y cable.
5
Skip to
682
Description
T1 ESF
Span A through D Framing set for ESF
T1 D4
Span A through D Framing set for D4
E1 120 ohms ESF
Span A through D Line Impedance set for ESF
Figure 276, DS1 Converter Connections — Part 1,
Connecting Through a Channel Service Unit
on page 683.
on page 685.
SI Installation and Upgrades
June 2004