Avaya MCC1 Installation And Upgrades page 194

Install Fiber Optic Cable Pass-Thru Kit for SCC1 (Single-Carrier) Cabinets
Install the fiber optic cable pass-thru kit (SCC1)
Prepare the cabinet
Return to Task List
1
Verify the equipment received.
See Figure 22, Fiber pass-thru kit equipment,
appearance and may ship in separate packages.
2
Remove the 2 perforated metal panels from the rear of the cabinet. See
rear panels,
3
Remove the front door.
NOTE:
Administration may be required before removing the circuit pack in the following step.
4
Determine which slot (1 or 2) will contain the new fiber optic circuit pack. Remove the circuit
pack or the blanking plate from this slot.
NOTE:
For duplicated systems, you must install the duplication interface circuit pack in slot 1.
NOTE:
If a circuit pack is removed from the required slot, it must be installed into a different slot
in the cabinet. All translations associated with this circuit pack must also be moved.
5
Remove the circuit pack or the blanking plate from the slot next to the slot determined in
Two consecutive open slots are required to install the fiber optic adapter.
NOTE:
If a circuit pack was removed in
procedure.
6
From the rear, remove the I/O cable connector plate associated with the slot that will contain the
new fiber optic circuit pack.
7
Using a supplied cable tie, secure the removed I/O connector plate to the back of the cabinet or to
nearby cabling. This will keep it from moving loosely inside the cabinet.
8
From the rear, remove the I/O cable connector associated with the slot that will contain the new
fiber optic circuit pack. See
9
Using a supplied cable tie, secure the removed I/O connector to nearby cabling. See
Secure the I/O cable connector,
Return to Task List
194
on page 196.
Figure 24, Remove the I/O cable connector,
on page 198.
on page 195. Actual equipment may vary in
Step 5, it will be replaced into the same slot in the next
SI Installation and Upgrades
Figure 23, Remove the
Step 4.
on page 197.
Figure 25,
June 2004