Install and Wire Telephones
The wiring procedures are the same for most of the Avaya Media Gateway telephones and other
equipment.
This task list provides wiring examples of similar installation procedures. These are examples only;
actual wiring procedures may vary at each site.
After installing the hardware, the data for telephone features must be administered. These procedures are
provided in the Administrator's Guide for Avaya Communication Manager (555-233-506).
NOTE:
Refer to the
equipment.
Task List: Wiring Examples and Wiring Procedures
•
Voice and Data Terminals
•
Analog Tie Trunk Example
•
Digital Tie Trunk Example
•
DS1 Tie Trunk Example
•
Auxiliary Connector Outputs
•
Three-Pair and Four-Pair Modularity
•
Adjunct Power Connection Locations
•
Attendant Console Example
•
Connect External Alarm Indicators and Auxiliary Power
•
Connect Power Distribution Unit External Alarm Wires
•
Remote Network Interface
•
Off-Premises or Out-of-Building Stations
•
Emergency Transfer Units and Associated Telephones
•
808A Emergency Transfer Panel and Telephone Installation Examples
•
Install External Ringing
•
Install the Queue Warning Indicator
These links provide useful reference information:
•
Voice and Data Terminals
•
Circuit Pack and Auxiliary Equipment Classifications
•
Connector and Cable Diagrams (Pinout Charts)
SI Installation and Upgrades
June 2004
Chapter , "Adjuncts and Peripherals"
on page 500
on page 506
on page 507
on page 508
on page 510
on page 514
on page 515
on page 516
on page 523
on page 526
on page 544
on page 545
on page 500
Install and Wire Telephones
Task List: Wiring Examples and Wiring Procedures
to install the necessary peripheral
on page 519
on page 520
on page 532
on page 533
on page 567
on page 771
499