Avaya MCC1 Installation And Upgrades page 612

Add IP Solutions
Task List: Upgrade TN802 to TN2302AP
From the rear of the cabinet:
6
Disconnect the amphenol connector on the existing external cable assembly from the backplane
connector corresponding to the TN802 circuit pack.
7
Connect the amphenol connector of the TN2302AP Amphenol adapter to the backplane connector
corresponding to the slot selected for the TN2302AP circuit pack.
NOTE:
The TN802 occupied 3 slots, and the cable was connected to the rightmost backplane slot.
For convenience use the same rightmost slot vacated by the TN802 circuit pack for the
TN2302AP circuit pack.
8
Connect the network cable to the Ethernet connector on the TN2302AP Amphenol adapter.
Return to Task List
Install the Circuit Packs
Return to Task List
1
If replacing the TN799 circuit pack, install the TN799DP circuit pack in the slot vacated by the
TN799 circuit pack.
2
For convenience install the TN2302AP circuit pack in the rightmost slot vacated by the TN802.
The other 2 slots are now available for other circuit packs.
When you plug in the TN2302AP IP Media Processor, the circuit pack starts to boot. The RED LED stays
on until an IP address is assigned to the circuit pack.
3
Type list configuration all
circuit packs.
Administer and Test
Return to Task List
1
Administer the TN799DP C-LAN. Refer to the Administration for Network Connectivity for
Avaya™ Communication Manager (555-233-504).
2
Administer the IP Media Processor, which is usually done remotely. Call your service
representative to start the process.
3
Complete the administration and testing.
See Perform Initial Administration Steps for C-LAN and IP Media Processor
Test the External Connection to the LAN
Return to Task List
612
and press Enter to verify that the system recognizes the TN2302AP
on page 610 for detailed instructions.
on page 607 and
SI Installation and Upgrades
June 2004