Avaya MCC1 Installation And Upgrades page 579

Configuring the system for the TN2501AP
1
At the SAT, type
The System Configuration report appears. Use this report to ensure that the switch recognizes the
TN2501AP circuit pack after it is latched in the carrier slot.
2
Verify the following field values:
— Board Type shows
— Code is
3
At the SAT, type
The IP Node Names screen appears. Use this screen to administer the circuit pack's node name.
4
Type a unique name in the Name field.
This name is recognized only within the switch, and does not need to match the node name on
your network.
5
Enter the IP Address .
You can get this information from the network manager.
6
Press Enter to save the changes.
7
Type change ip-interfaces
The IP Interfaces screen appears. Use this screen to administer an IP interface , which
associates the circuit pack with an IP address.
8
Set the Enable Eth Pt field to y.
9
Set the Type field to VAL.
10
Type the circuit pack location in the Slot field (UUCSS).
If a TN2501AP circuit pack is not at this location when you submit the screen, the system prompts
you to enter a VAL circuit pack location.
11
In the Node Name field, enter the Node Name you entered in
If you press Help, a list of administered node names appears (including the name you
administered with the
12
Set the Subnet Mask field according to your network requirements.
Gateway Address is usually the same as the TN2501AP circuit pack's IP address, usually
with the fourth octet changed. Be sure to set this address according to your network requirements.
13
Press Enter to save the changes.
14
Type
add data-module extension
The Data Module screen appears. Use this screen to administer the data module that is associated
with the TN2501AP ethernet port.
15
Set the Type field to ethernet.
16
Set the Port field to correspond to the circuit pack location.
The port number (final two digits) is always 33 for the TN2501AP circuit pack.
17
Set the Link field to an unassigned or next-available link number.
18
Set the Network uses 1's for Broadcast Address field according to the your
network requirements.
19
Type a unique name in the Name field.
SI Installation and Upgrades
June 2004
list configuration board board-location
VAL-ANNOUNCEMENT
TN2501AP
and press Enter.
change node-names ip
and press Enter.
change node-names ip
and press Enter.
Install Additional Hardware
Add a TN2501AP Announcement Circuit Pack
and press Enter.
Step 4.
command), and you can select from the list.
579