Power Inline; Power Over Ethernet Commands - Alcatel OS-LS-6224 User Manual

Power over Ethernet Commands

Command Function

power inline

Configures the administrative mode of inline power on an
interface.
power inline Adds a comment or description of the powered device type to
powered-device enable the user to remember what is attached to the interface. To
remove the description, use the no form of this command.
power inline priority Configures the inline power management priority of the interface.
To return to the default configuration, use the no form of this
command.
power inline Configures the threshold for initiating inline power usage alarms.
usage-threshold To return to the default configuration, use the no form of this
command.
power inline traps Enables inline power traps. To disable inline power traps, use the
enable no form of this command.
show power inline Displays the information about inline power.
.
power inline
The power inline Interface Configuration (Ethernet) mode command configures the
administrative mode of inline power on an interface.
Syntax
power inline {auto | never}
Parameters
• auto — Enables the device discovery protocol and, if found, supplies power
to the device.
• never — Disables the device discovery protocol and stops supplying power
to the device.
Default Setting
The device discovery protocol is enabled.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
There are no user guidelines for this command.
Example
The following example enables powered device discovery protocol on port 1/e1, so
that power will be supplied to a discovered device.
Console(config)# interface ethernet 1/e1
Console(config-if)# power inline auto
Table 4-25. Power over Ethernet Commands
Power over Ethernet Commands
4
Mode Page
ICE 4-380
ICE 4-470
ICE 4-473
GC 4-473
GC 4-474
UE 4-475
471