Defining Bandwidth Settings; Figure 3-122. Queue Priority Page - Alcatel OS-LS-6224 User Manual

Web – Click Policy, General QoS, General, Queue Priority. Define the fields, and
click Apply.
CLI – The following is an example of the CLI commands used to enable QoS:
console(config)# priority-queue out num-of-queues 4

Defining Bandwidth Settings

The Bandwidth Configuration Page allows network managers to define the
bandwidth settings for specified egress and ingress interfaces. Modifying queue
scheduling affects the queue settings globally.
Rate Limits and Shaping are defined per interface:
• Rate Limit sets the maximum bandwidth allowed on an interface.
• Shaping of network traffic may be defined over LAGs. LAGs can accommodate GE
and FE interfaces.
Command Attributes
• Unit No. — Indicates the stacking member for which this bandwidth configuration
is displayed.
• Interface — Indicates the interface for which this bandwidth information is
displayed. The possible field values are:
• Port — Indicates the port for which the bandwidth settings are displayed.
• LAG — Indicates the LAG for which the bandwidth settings are displayed.
• Ingress Rate Limit — Indicates the traffic limit for ingress interfaces. The possible
field values are:

Figure 3-122. Queue Priority Page

Configuring Quality of Service
3
4-493
237