Alcatel OS-LS-6224 User Manual page 489

Command Usage
To test optical transceivers, ensure a fiber link is present.
Examples
The following examples display the optical transceiver diagnostics.
Console# show fiber-ports optical-transceiver
Port Temp
---- ------
1/g1 W
1/g2 OK
1/g3 Copper
Temp – Internally measured transceiver temperature.
Voltage – Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX received power.
Tx Fault – Transmitter fault
LOS – Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
Console# show fiber-ports optical-transceiver detailed
Port Temp
[C]
---- -------
1/g1 48
1/g2 43
1/g3 Copper
Temp – Internally measured transceiver temperature.
Voltage – Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX received power.
Tx Fault – Transmitter fault
LOS – Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
Voltage Current
-------- --------
OK E
OK OK
Voltage Current
[Volt] [mA]
------ -------
5.15 50
5.15 10
PHY Diagnostics Commands
Output Input
Power Power
------ -----
OK OK
OK OK
Output Input
Power Power
[mWatt] [mWatt]
------ -----
1.789 1.789
1.789 1.789
4
TX Fault LOS
--------- ---
OK OK
E OK
TX Fault LOS
------- ---
No No
No No
465