Snmp Commands - Alcatel OS-LS-6224 User Manual

4
Command Line Interface

SNMP Commands

.
Command
snmp-server
community
snmp-server view
snmp-server group
snmp-server user
snmp-server
engineID local
snmp-server enable
traps
snmp-server filter
snmp-server host
snmp-server v3-host Specifies the recipient of Simple Network Management Protocol
snmp-server trap
authentication
snmp-server contact Configures the system contact (sysContact) string. To remove
snmp-server
location
snmp-server set
show snmp
show snmp engineid Displays the ID of the local Simple Network Management Protocol
show snmp views
show snmp groups
show snmp filters
show snmp users
.
530
Table 4-29. SNMP Commands
Function
Configures the community access string to permit access to the
SNMP protocol. To remove the specified community string, use
the no form of this command.
Creates or updates a Simple Network Management Protocol
(SNMP) server view entry. To remove a specified SNMP server
view entry, use the no form of this command.
Configures a new Simple Management Protocol (SNMP) group or
a table that maps SNMP users to SNMP views. To remove a
specified SNMP group, use the no form of this command.
Configures a new SNMP Version 3 user. To remove a user, use
the no form of this command.
Specifies the Simple Network Management Protocol (SNMP)
engineID on the local device. To remove the configured engine ID,
use the no form of this command.
Enables the device to send SNMP traps. To disable SNMP traps,
use the no form of the command.
Creates or updates a Simple Network Management Protocol
(SNMP) server filter entry. To remove the specified SNMP server
filter entry, use the no form of this command.
Specifies the recipient of Simple Network Management Protocol
Version 1 or Version 2 notifications. To remove the specified host,
use the no form of this command.
Version 3 notifications. To remove the specified host, use the no
form of this command.
Enables the device to send SNMP traps when authentication fails.
To disable SNMP failed authentication traps, use the no form of
this command.
system contact information, use the no form of the command.
Configures the system location string. To remove the location
string, use the no form of this command.
Defines the SNMP MIB value.
Displays the SNMP status.
(SNMP) engine.
Displays the configuration of views.
Displays the configuration of groups.
Displays the configuration of filters.
Displays the configuration of users.
Mode Page
GC 4-531
GC 4-532
GC 4-533
GC 4-534
GC 4-536
GC 4-537
GC 4-538
GC 4-538
GC 4-540
GC 4-541
GC 4-541
GC 4-542
GC 4-543
PE 4-543
PE 4-545
PE 4-546
PE 4-547
PE 4-548
PE 4-549