Configuring Snmp; Figure 3-32. Dns Host Mapping Page - Alcatel OS-LS-6224 User Manual

3

Configuring SNMP

Figure 3-32. DNS Host Mapping Page

CLI -The following in an example of the DNS Host Mapping Commands:
Console(config)# ip host accounting.abc.com 176.10.23.1 4-433
Configuring SNMP
Simple Network Management Protocol (SNMP) is a communication protocol
designed specifically for managing devices on a network. Equipment commonly
managed with SNMP includes switches, routers and host computers. SNMP is
typically used to configure these devices for proper operation in a network
environment, as well as to monitor them to evaluate performance or detect potential
problems.
Managed devices supporting SNMP contain software, which runs locally on the
device and is referred to as an agent. A defined set of variables, known as managed
objects, is maintained by the SNMP agent and used to manage the device. These
objects are defined in a Management Information Base (MIB) that provides a
standard presentation of the information controlled by the agent. SNMP defines both
the format of the MIB specifications and the protocol used to access this information
over the network.
The switch includes an onboard agent that supports SNMP versions 1, 2c, and 3.
This agent continuously monitors the status of the switch hardware, as well as the
traffic passing through its ports. A network management station can access this
information using software such as HP OpenView. Access to the onboard agent
using SNMP v1 and v2c is controlled by community strings. To communicate with
the switch, the management station must first submit a valid community string for
authentication.
Access to the switch using SNMPv3 provides additional security features that cover
message integrity, authentication, and encryption; as well as controlling user access
to specific areas of the MIB tree.
The SNMPv3 security structure consists of security models, with each model having
its own security levels. There are three security models defined, SNMPv1,
SNMPv2c, and SNMPv3. Users are assigned to "groups" that are defined by a
security model and specified security levels. Each group also has a defined security
access to set of MIB objects for reading and writing, which are known as "views."
The switch has a default view (all MIB objects) and default groups defined for
security models v1 and v2c. The following table shows the security models and
levels available and the system default settings.
87