Dot1X Guest-Vlan - Alcatel OS-LS-6224 User Manual

4
Command Line Interface
Parameters
• forward — Forwards frames with source addresses that are not the
supplicant address, but does not learn the source addresses.
• discard — Discards frames with source addresses that are not the
supplicant address.
• discard-shutdown — Discards frames with source addresses that are not
the supplicant address. The port is also shut down.
• trap — Indicates that SNMP traps are sent.
• seconds — Specifies the minimum amount of time in seconds between
consecutive traps. (Range: 1- 1000000
Default Setting
Frames with source addresses that are not the supplicant address are
discarded.
No traps are sent.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
The command is relevant when multiple hosts is disabled and the user has
been successfully authenticated.
Example
The following example forwards frames with source addresses that are not the
supplicant address and sends consecutive traps at intervals of 100 seconds.
Console(config-if)# dot1x single-host-violation forward trap 100
Related Commands
dot1x multiple-hosts
show dot1x advanced

dot1x guest-vlan

The dot1x guest-vlan Interface Configuration mode command defines a guest
VLAN. To return to the default configuration, use the no form of this command.
Syntax
dot1x guest-vlan
no dot1x guest-vlan
Default Setting
No VLAN is defined as a guest VLAN.
Command Mode
Interface Configuration (VLAN) mode
288
)