Figure 3-68. Optical Transceiver Page - Alcatel OS-LS-6224 User Manual

3
Configuring the Switch
Command Attributes
• Unit No. — Indicates the stacking member for which the interface configuration
information is displayed.
• Port — Displays the IP address of the port on which the cable is tested.
• Temperature — Displays the temperature (C) at which the cable is operating.
• Voltage — Displays the voltage (V) at which the cable is operating.
• Current — Displays the current (mA) at which the cable is operating.
• Output Power — Indicates the rate (mW) at which the output power is transmitted.
• Input Power — Indicates the rate (mW) at which the input power is transmitted.
• Transmitter Fault — Indicates if a fault occurred during transmission.
• Loss of Signal — Indicates if a signal loss occurred in the cable.
• Data Ready — Indicates the transceiver has achieved power up and data is ready.
Web – Click Physical, Diagnostics, Optical Transceivers.
CLI – The following is an example of the CLI commands used to fiber cables:
Console# show fiber-ports optical-transceiver
Port Temp
---- ----
1/g1 W
144

Figure 3-68. Optical Transceiver Page

Voltage Current
------- -------
OK E
Power
Output Input
------ -----
OK OK
4-464
TX Fault LOS
------- ---
OK OK