Permit (Mac) - Alcatel OS-LS-6224 User Manual

4
Command Line Interface
no mac access-list name
Parameters
• name — Specifies the name of the ACL.
Default Setting
The default for all ACLs is deny all.
Command Mode
Global Configuration mode
Command Usage
There are no user guidelines for this command.
Example
The following example shows how to create a MAC ACL.
Console(config)# mac access-list macl-acl1
Console(config-mac-al)#
Related Commands

permit (MAC)

deny (MAC)
show access-lists
service-acl
match
permit (MAC)
The permit MAC-Access List Configuration mode command defines permit
conditions of an MAC ACL.
Syntax
permit {any | {host source source-wildcard} any | {destination
destination-wildcard}} [vlan vlan-id] [cos cos cos-wildcard] [ethtype eth-type]
[inner-vlan vlan-id]
Parameters
• source — Specifies the source MAC address of the packet.
• source-wildcard — Specifies wildcard bits to be applied to the source MAC
address. Use 1s in bit positions to be ignored.
• destination — Specifies the MAC address of the host to which the packet is
being sent.
• destination-wildcard — Specifies wildcard bits to be applied to the
destination MAC address. Use 1s in bit positions to be ignored.
• vlan-id — Specifies the ID of the packet vlan. (Range: 0-4095)
• cos — Specifies the Class of Service (CoS) for the packet. (Range: 0-7)
312