Deny (Management) - Alcatel OS-LS-6224 User Manual

4
Command Line Interface
permit ip-source ip-address [mask mask | prefix-length] [ethernet
interface-number | vlan vlan-id | port-channel port-channel-number |
service service]
Parameters
• interface-number — A valid Ethernet port number.
• vlan-id — A valid VLAN number.
• port-channel-number — A valid port channel index.
• ip-address — A valid source IP address.
• mask — A valid network mask of the source IP address.
• prefix-length — Number of bits that comprise the source IP address prefix.
The prefix length must be preceded by a forward slash (/). (Range: 0 - 32)
• service — Service type. Possible values are:
telnet, ssh, http, https and snmp.
Default Setting
If no permit rule is defined, the default is set to deny.
Command Mode
Management Access-list Configuration mode
Command Usage
Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP
address is defined on the appropriate interface.
The system supports up to 128 management access rules.
Example
The following example permits all ports in the mlist access list.
Console(config)# management access-list mlist
Console(config-macl)# permit
Related Commands
management access-list

deny (Management)

show management access-list
deny (Management)
The deny Management Access-List Configuration mode command defines a deny
rule.
Syntax
deny [ethernet interface-number | vlan vlan-id | port-channel
port-channel-number] [service service]
458