Connect The Power Supply; Connect To The Serial Port - Alcatel OmniSwitch/Router Getting Started Manual

b. Use the holes in the wall-mounting bracket and
the chassis as a guide, measure the correct
placement for the wall-mounting screws.
c. Drill holes in the wall for the wall-mounting
screws.
d. Screw the wall-mounting screws into the wall.
e. Attach one bracket to the back end of the chas-
sis, using the Phillips flat-head screws that came
with the chassis.
f. Attach the second bracket to the opposite back
end of the chassis using the remaining screws.
g. Carefully lift the chassis and hang it on the wall-
mounted screws.

5. Connect the Power Supply

Attach a power cord to one or more of the power
supplies. The power supplies are located in the bottom
bays of the chassis.
When more than one power supply is used, they act as
redundant, power-sharing power sources. During
normal operation the power supplies share the power
load. In the event one power supply fails, the other
acts as a back up and picks up the power load from
the failed power supply.
o Power Cord Safety Precautions o
In the event that your power cord is
lost or damaged, refer to the Omni
Switch/Router User Manual for instruc-
tions on how to obtain a replacement.
European cords
( ) type. See the Omni Switch/
HAR
Router User Manual for further infor-
mation.

6. Connect to the Serial Port

Attach a serial cable to the female serial port connec-
tor on the module's front panel. Connect the other
MPX
end of the serial cable to a workstation equipped with
terminal emulation software. You will use this connec-
tion to enter initial configuration values for the switch.
Later you can use this connection to perform more
sophisticated network management tasks, such as
configuring , setting up routing, and monitoring
VLANs
statistics.
be Harmonized
must
Installing Your Switch 7