3
Configuring the Switch
Command Attributes
• Interface — Displays the interfaces on which ARP Inspection Trust mode can be
enabled. The possible field values are:
• Units — Indicates the port on which ARP Inspection Trust mode is enabled.
• LAGs — Indicates the LAG on which ARP Inspection Trust mode is enabled.
• Trust — Indicates if the selected interface is trusted or untrusted. The possible field
values are:
• Enable — Indicates that the port or LAG is a trusted interface, and ARP
inspection is not performed on the ARP requests/replies sent to/from the
interface.
• Disable — Indicates the port or LAG is a trusted interface, and ARP inspection
is performed on the ARP requests/replies sent to/from the interface. This is the
default value if ARP Inspection is enabled.
Web – Click Security, DHCP Snooping, ARP Inspection, Trusted Interface. Define
the fields and click Apply.
Figure 3-86. ARP Inspection Trusted Interface Page
Defining ARP Inspection List
The ARP Inspection List Page provides information for creating static ARP Binding
Lists. ARP Binding Lists contains the List Name, IP address and MAC address
which are validated against ARP requests.
Command Attributes
• ARP Inspection List Name — Name of the Inspection List, which may be an
existing list or a new list.
180