Remote Log Configuration; Figure 3-10. Flash Logs Page - Alcatel OS-LS-6224 User Manual

Web – Click System, System Management, Logs, Flash.
CLI – The following is an example of the CLI commands used to display FLASH
logs:
Console# show logging file
Logging is enabled.
Console Logging: Level info. Console Messages: 0 Dropped.
Buffer Logging: Level info. Buffer Messages: 62 Logged, 62 Displayed, 200
Max.
File Logging: Level debug. File Messages: 11 Logged, 51 Dropped.
SysLog server 12.1.1.2 Logging: warning. Messages: 14 Dropped.
SysLog server 1.1.1.1 Logging: info. Messages: 0 Dropped.
01-Jan-2000 01:12:01:%COPY-W-TRAP: The copy operation was completed
successfully
01-Jan-2000 01:11:49:%LINK-I-Up: 1/e11
01-Jan-2000 01:11:46:%LINK-I-Up: 1/e12
01-Jan-2000 01:11:42:%LINK-W-Down: 1/e13

Remote Log Configuration

The Remote Log Page allows you to configure the logging of messages that are
sent to syslog servers or other management stations. You can also limit the event
messages sent to only those messages at or above a specified level.
Command Attributes
• Server — Specifies the IP address of the server to which logs can be sent.
• UDP Port — Defines the UDP port to which the server logs are sent. The possible
range is 1 - 65535. The default value is 514.
• Facility — Defines an application from which system logs are sent to the remote
server. Only one facility can be assigned to a single server. If a second facility level

Figure 3-10. FLASH Logs Page

Managing System Logs
4-612
3
47