Defining Gvrp; Figure 3-112. Garp Configuration Page - Alcatel OS-LS-6224 User Manual

Command Attributes
• Copy from Entry Number — Indicates the row number from which GARP
parameters are copied.
• To Entry Number — Indicates the row number to which GARP parameters are
copied.
• Interface — Displays the port or LAG on which GARP is enabled.
• Join Timer— Indicates the amount of time, in centiseconds, that PDUs are
transmitted. The default value is 20 centiseconds.
• Leave Timer— Indicates the amount of time lapse, in centiseconds, that the
device waits before leaving its GARP state. Leave time is activated by a Leave All
Time message sent/received, and cancelled by the Join message received. Leave
time must be greater than or equal to three times the join time. The default value
is 60 centiseconds.
• Leave All Timer — Indicates the amount of time lapse, in centiseconds, that all
device waits before leaving the GARP state. The leave all time must be greater
than the leave time. The default value is 1000 centiseconds.
Web – Click Layer 2, VLAN, GARP. Enable or disable GARP, and click Apply.
CLI – The following is an example of the GARP configuration commands:
Console(config)# interface ethernet 1/e6
Console(config-if)# garp timer leave 900

Defining GVRP

GARP VLAN Registration Protocol (GVRP) defines a way for switches to exchange
VLAN information in order to register VLAN members on ports across the network.

Figure 3-112. GARP Configuration Page

Defining VLAN Groups
4-380
4-408
3
217