Spanning-Tree Portfast - Alcatel OS-LS-6224 User Manual

no spanning-tree port-priority
Parameters
• priority — The priority of the port. (Range: 0 - 240 in multiples of 16)
Default Setting
The default port priority for IEEE Spanning TreeProtocol (STP) is 128.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
Command Usage
There are no user guidelines for this command.
Example
The following example configures the spanning priority on Ethernet port 1/e15 to 96.
Console(config)# interface ethernet 1/e15
Console(config-if)# spanning-tree port-priority 96
Related Commands
spanning-tree forward-time
spanning-tree hello-time
spanning-tree max-age
spanning-tree priority
spanning-tree disable
spanning-tree cost

spanning-tree portfast

spanning-tree link-type
show spanning-tree
spanning-tree portfast
The spanning-tree portfast Interface Configuration mode command enables
PortFast mode. In PortFast mode, the interface is immediately put into the
forwarding state upon linkup without waiting for the standard forward time delay. To
disable PortFast mode, use the no form of this command.
Syntax
spanning-tree portfast [auto]
no spanning-tree portfast
Parameters
• auto — Specifies that the software waits for 3 seconds (with no BPDUs
received on the interface) before putting the interface into PortFast mode.
Spanning-Tree Commands
4
559