Parameters
• dscp- list — Specifies up to 8 DSCP values separated by a space.
(Range: 0-63)
• dscp-mark-down — Specifies the DSCP value to mark down. (Range: 0-63)
Default Setting
The default map is the Null map, which means that each incoming DSCP
value is mapped to the same DSCP value.
Command Mode
Global Configuration mode.
Command Usage
DSCP values 3,11,19... cannot be remapped to other values.
·
Example
The following example marks down incoming DSCP value 3 as DSCP value 43 on
the policed-DSCP map.
Console(config)# qos map policed-dscp 3 to 43
Reserved DSCP. DSCP 3 was not configured.
Related Commands
show qos interface
qos map dscp-queue
qos map dscp-queue
The qos map dscp-queue Global Configuration mode command modifies the
DSCP to CoS map. To return to the default map, use the no form of this command.
Syntax
qos map dscp-queue dscp-list to queue-id
no qos map dscp-queue
Parameters
• dscp-list — Specifies up to 4 DSCP values separated by a space.
(Range: 0 - 63)
• queue-id — Specifies the queue number to which the DSCP values are
mapped.
Default Setting
The following table describes the default map.
DSCP value
Queue-ID
0-15
16-31
1
2
QoS Commands
32-47
48-63
3
4
4
499