Duplex - Alcatel OS-LS-6224 User Manual

back-pressure
show interfaces configuration
show interfaces status

duplex

The duplex Interface Configuration (Ethernet) mode command configures the full/
half duplex operation of a given Ethernet interface when not using auto-negotiation.
To restore the default configuration, use the no form of this command.
Syntax
duplex {half | full}
no duplex
Parameters
• half — Forces half-duplex operation
• full — Forces full-duplex operation
Default Setting
The interface is set to full duplex.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
When configuring a particular duplex mode on the port operating at 10/100
Mbps, disable the auto-negotiation on that port.
Half duplex mode can be set only for ports operating at 10 Mbps or 100 Mbps.
Example
The following example configures the duplex operation of Ethernet port 1/e5 to full
duplex operation.
Console(config)# interface ethernet 1/e5
Console(config-if)# duplex full
Related Commands
shutdown
speed
negotiation
flowcontrol
mdix
back-pressure
show interfaces configuration
Ethernet Configuration Commands
4
385