3
Configuring the Switch
• Bridge ID — Indicates the bridge ID of the selected instance.
• Remaining Hops — Indicates the number of hops remaining to the next
destination.
Web – Click Layer 2, Spanning Tree, MSTP, Instance Settings. Define the fields and
Click Apply.
CLI –The following is an example of the MSTP Instance Settings commands:
Console(config)# spanning-tree mst configuration
Console(config-mst)# instance 1 add vlan 10-20
Defining MSTP Interface Settings
You can configure the STP interface settings for an MSTP Instance using the MSTP
Interface Settings Page.
Command Attributes
• Instance ID — Lists the MSTP instances configured on the device. Possible field
range is 0-15.
• Interface — Displays the interface for which the MSTP settings are displayed. The
possible field values are:
• Port — Specifies the port for which the MSTP settings are displayed.
• LAG — Specifies the LAG for which the MSTP settings are displayed.
• STP Port Status — Indicates if STP is enabled on the port. The possible field
values are:
• Enabled — Indicates that STP is enabled on the port.
200
Figure 3-100. MSTP Instance Settings Page
4-568
4-568